最近閲覧した製品
SF 26PT
コンサルタント向け資料
製品番号を選択してください:
テキストをコピー
コピーされました!
エラーが発生しました。しばらくしてからもう一度お試しください。
SF 26PT
- Provide a two-way, plastic enclosure, pendant speaker that shall provide an internal transformer.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
- Driver Requirements
- Shall consist of a 6.5" (165 mm) polypropylene woofer with moisture resistant coating and a 3/4” (19 mm) PEI dome tweeter
- Performance Requirements
- Shall provide a frequency range of 70 Hz to 20 kHz, -10 dB below average SPL, measured on-axis in full space (per IEC 60268-5)
- Shall provide a power handling capacity of 65 watts (rms) continuous pink noise (per IEC 60268-5) and 130 watts (rms) continuous program
- Shall provide a nominal sensitivity of 86 dB SPL (1 W, 1 m) measured in full space (per IEC 60268-5)
- Shall provide a nominal impedance of 8 ohms per speaker
- Shall provide a nominal conical coverage angle of 95° (1 kHz to 4 kHz)
- Electrical Requirements
- Shall support 8 ohm direct or 70/100 volt connection from power amplifiers
- Shall provide a six-position power tap selector, located at the bottom of the enclosure under a removable speaker grille
- Shall provide selectable rotary switch taps for 70 volt operation, including 64 watts, 32 watts, 16 watts, 8 watts, and 8 ohms direct
- Shall provide selectable rotary switch taps for 100 volt operation, including null, 64 watts, 32 watts, 16 watts, and 8 ohms direct
- Shall support one incoming and one outgoing speaker level signal on two splicing connectors
- Shall support wiring multiple speakers using parallel or loop-through wiring
- Shall support Extron PendantConnect speaker cable, model PCC-2 18
- Speaker Enclosure Requirements
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- Shall measure 11.6 inches (295 mm) in height
- Shall measure 9.0 inches (229 mm) in diameter at its widest point
- Shall be available with a white or black, paintable finish
- Shall include removable cap for the top of the enclosure such that the connection points are not visible when the cap is in place
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- General Requirements
- Shall be sold in pairs
- Shall include 30 feet (9.1 m) of Extron PendantConnect PCC-2 18 speaker cable that incorporates the speaker wires, a steel support cable, and a steel safety cable into a single outer jacket
- Shall meet regulatory compliances
- Shall meet safety compliances under CE, UL1480
- Shall meet UL 1480 for commercial and professional audio systems
- Shall comply with appropriate requirements for RoHS and WEEE
- Shall provide five year parts and labor warranty
- Driver Requirements
- Approved device shall be the Extron SF 26PT, part numbers 60-1752-02 for black or 60-1752-03 for white; no alternates or equals.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
SF 26PT
- Provide a two-way, plastic enclosure, pendant speaker that shall provide an internal transformer.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
- Driver Requirements
- Shall consist of a 6.5" (165 mm) polypropylene woofer with moisture resistant coating and a 3/4” (19 mm) PEI dome tweeter
- Performance Requirements
- Shall provide a frequency range of 70 Hz to 20 kHz, -10 dB below average SPL, measured on-axis in full space (per IEC 60268-5)
- Shall provide a power handling capacity of 65 watts (rms) continuous pink noise (per IEC 60268-5) and 130 watts (rms) continuous program
- Shall provide a nominal sensitivity of 86 dB SPL (1 W, 1 m) measured in full space (per IEC 60268-5)
- Shall provide a nominal impedance of 8 ohms per speaker
- Shall provide a nominal conical coverage angle of 95° (1 kHz to 4 kHz)
- Electrical Requirements
- Shall support 8 ohm direct or 70/100 volt connection from power amplifiers
- Shall provide a six-position power tap selector, located at the bottom of the enclosure under a removable speaker grille
- Shall provide selectable rotary switch taps for 70 volt operation, including 64 watts, 32 watts, 16 watts, 8 watts, and 8 ohms direct
- Shall provide selectable rotary switch taps for 100 volt operation, including null, 64 watts, 32 watts, 16 watts, and 8 ohms direct
- Shall support one incoming and one outgoing speaker level signal on two splicing connectors
- Shall support wiring multiple speakers using parallel or loop-through wiring
- Shall support Extron PendantConnect speaker cable, model PCC-2 18
- Speaker Enclosure Requirements
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- Shall measure 11.6 inches (295 mm) in height
- Shall measure 9.0 inches (229 mm) in diameter at its widest point
- Shall be available with a white or black, paintable finish
- Shall include removable cap for the top of the enclosure such that the connection points are not visible when the cap is in place
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- General Requirements
- Shall be sold in pairs
- Shall include 30 feet (9.1 m) of Extron PendantConnect PCC-2 18 speaker cable that incorporates the speaker wires, a steel support cable, and a steel safety cable into a single outer jacket
- Shall meet regulatory compliances
- Shall meet safety compliances under CE, UL1480
- Shall meet UL 1480 for commercial and professional audio systems
- Shall comply with appropriate requirements for RoHS and WEEE
- Shall provide five year parts and labor warranty
- Driver Requirements
- Approved device shall be the Extron SF 26PT, part numbers 60-1752-02 for black or 60-1752-03 for white; no alternates or equals.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
SF 26PT
- Provide a two-way, plastic enclosure, pendant speaker that shall provide an internal transformer.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
- Driver Requirements
- Shall consist of a 6.5" (165 mm) polypropylene woofer with moisture resistant coating and a 3/4” (19 mm) PEI dome tweeter
- Performance Requirements
- Shall provide a frequency range of 70 Hz to 20 kHz, -10 dB below average SPL, measured on-axis in full space (per IEC 60268-5)
- Shall provide a power handling capacity of 65 watts (rms) continuous pink noise (per IEC 60268-5) and 130 watts (rms) continuous program
- Shall provide a nominal sensitivity of 86 dB SPL (1 W, 1 m) measured in full space (per IEC 60268-5)
- Shall provide a nominal impedance of 8 ohms per speaker
- Shall provide a nominal conical coverage angle of 95° (1 kHz to 4 kHz)
- Electrical Requirements
- Shall support 8 ohm direct or 70/100 volt connection from power amplifiers
- Shall provide a six-position power tap selector, located at the bottom of the enclosure under a removable speaker grille
- Shall provide selectable rotary switch taps for 70 volt operation, including 64 watts, 32 watts, 16 watts, 8 watts, and 8 ohms direct
- Shall provide selectable rotary switch taps for 100 volt operation, including null, 64 watts, 32 watts, 16 watts, and 8 ohms direct
- Shall support one incoming and one outgoing speaker level signal on two splicing connectors
- Shall support wiring multiple speakers using parallel or loop-through wiring
- Shall support Extron PendantConnect speaker cable, model PCC-2 18
- Speaker Enclosure Requirements
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- Shall measure 11.6 inches (295 mm) in height
- Shall measure 9.0 inches (229 mm) in diameter at its widest point
- Shall be available with a white or black, paintable finish
- Shall include removable cap for the top of the enclosure such that the connection points are not visible when the cap is in place
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- General Requirements
- Shall be sold in pairs
- Shall include 30 feet (9.1 m) of Extron PendantConnect PCC-2 18 speaker cable that incorporates the speaker wires, a steel support cable, and a steel safety cable into a single outer jacket
- Shall meet regulatory compliances
- Shall meet safety compliances under CE, UL1480
- Shall meet UL 1480 for commercial and professional audio systems
- Shall comply with appropriate requirements for RoHS and WEEE
- Shall provide five year parts and labor warranty
- Driver Requirements
- Approved device shall be the Extron SF 26PT, part numbers 60-1752-02 for black or 60-1752-03 for white; no alternates or equals.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
SF 26PT
- Provide a two-way, plastic enclosure, pendant speaker that shall provide an internal transformer.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
- Driver Requirements
- Shall consist of a 6.5" (165 mm) polypropylene woofer with moisture resistant coating and a 3/4” (19 mm) PEI dome tweeter
- Performance Requirements
- Shall provide a frequency range of 70 Hz to 20 kHz, -10 dB below average SPL, measured on-axis in full space (per IEC 60268-5)
- Shall provide a power handling capacity of 65 watts (rms) continuous pink noise (per IEC 60268-5) and 130 watts (rms) continuous program
- Shall provide a nominal sensitivity of 86 dB SPL (1 W, 1 m) measured in full space (per IEC 60268-5)
- Shall provide a nominal impedance of 8 ohms per speaker
- Shall provide a nominal conical coverage angle of 95° (1 kHz to 4 kHz)
- Electrical Requirements
- Shall support 8 ohm direct or 70/100 volt connection from power amplifiers
- Shall provide a six-position power tap selector, located at the bottom of the enclosure under a removable speaker grille
- Shall provide selectable rotary switch taps for 70 volt operation, including 64 watts, 32 watts, 16 watts, 8 watts, and 8 ohms direct
- Shall provide selectable rotary switch taps for 100 volt operation, including null, 64 watts, 32 watts, 16 watts, and 8 ohms direct
- Shall support one incoming and one outgoing speaker level signal on two splicing connectors
- Shall support wiring multiple speakers using parallel or loop-through wiring
- Shall support Extron PendantConnect speaker cable, model PCC-2 18
- Speaker Enclosure Requirements
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- Shall measure 11.6 inches (295 mm) in height
- Shall measure 9.0 inches (229 mm) in diameter at its widest point
- Shall be available with a white or black, paintable finish
- Shall include removable cap for the top of the enclosure such that the connection points are not visible when the cap is in place
- Shall provide a fire-resistant (UL94V-0) plastic, tapered cylindrical enclosure
- General Requirements
- Shall be sold in pairs
- Shall include 30 feet (9.1 m) of Extron PendantConnect PCC-2 18 speaker cable that incorporates the speaker wires, a steel support cable, and a steel safety cable into a single outer jacket
- Shall meet regulatory compliances
- Shall meet safety compliances under CE, UL1480
- Shall meet UL 1480 for commercial and professional audio systems
- Shall comply with appropriate requirements for RoHS and WEEE
- Shall provide five year parts and labor warranty
- Driver Requirements
- Approved device shall be the Extron SF 26PT, part numbers 60-1752-02 for black or 60-1752-03 for white; no alternates or equals.
- Two-way, plastic enclosure, pendant speaker with internal transformer for 8 ohm direct and 70/100 volt operation
アイテムをカートに追加する
Order Message Number
製品番号
注: Extron products using the Universal AC Outlet accept a number of different AC plug types. Before use, ensure that the device meets all regulatory requirements for your region and complies with all applicable local safety and electrical codes and standards.
現在の合計金額:
製品をEメールでシェア

SF 26PT
SoundField 165 mm 2ウェイペンダントスピーカー
Eメールアドレスを正しく入力してください。
ありがとうございます。Emailの送信が完了しました。
Eメール送信中にエラーが発生しました。しばらくしてからもう一度お試しください。