| MTP/HDMI U T A D |
| NOTE | *Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output. |
|
|
| Video |
|---|
| MTP analog input | |
| Gain | Unity |
| Maximum resolution, analog | Up to 2048x1080 or 1080p @ 60 Hz |
| Signal transmission distance, analog |  |
| HDMI digital input | |
| Maximum data rate | 4.95 Gbps (1.65 Gbps per color) |
| Maximum pixel clock | 165 MHz |
| Maximum resolution, digital | Up to 1920x1200 or 1080p @ 60 Hz |
| Signal transmission distance, digital |  |
| NOTE | The transmission distance varies greatly depending on the signal resolution and on the type of cable, graphics card, and display used in the system. |
|
| NOTE | Shielded twisted pair cable provides added protection from outside interference and increases overall signal transmission distance. Extron strongly recommends using shielded twisted pair for optimal performance. |
|
| Formats | RGB and YCbCr digital video |
| Standards | DVI 1.0, HDMI 1.2 |
|
| Video input and loop through |
|---|
| Number/signal type | |
| MTP input | 1 analog RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video input
1 component video (YUV bi-level or tri-level sync)
1 S-video
1 composite video
1 buffered RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video loop through |
| HDMI input | 1 single link HDMI (or DVI-D*) |
| Connectors | |
| MTP input | 1 female 15-pin HD (RGB, RGBS, RGsB, RsGsBs)
3 RCA (component video)
1 female 4-pin mini DIN (S-video)
1 RCA (composite video)
1 female 15-pin HD (RGB buffered loop through) |
| HDMI input | 1 female HDMI type A |
| Nominal level | For analog input:
1 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video |
| Minimum/maximum levels | For analog input: 0.3 V to 1.45 Vp-p |
| Impedance | For analog input: 75 ohms |
| Horizontal frequency | For analog input: 15 kHz to 130 kHz |
| Vertical frequency | For analog input: 30 Hz to 150 Hz |
| Return loss | For analog input: <-30 dB @ 5 MHz |
| DC offset (max. allowable) | For analog input: 250 mV |
|
| Video output |
|---|
| Number/signal type | |
| MTP output | 1 set of proprietary analog signals |
| HDMI digital output | 1 set of proprietary digital signals |
| Connectors | |
| MTP output | 1 female RJ-45 |
| HDMI digital output | 2 female RJ-45 |
|
| Sync — analog inputs |
|---|
| Input type | RGBHV, RGBS, RGsB, RsGsBs |
| Standards | NTSC 3.58, NTSC 4.43, PAL, SECAM |
| Input level | 3.5 V to 5.5 Vp-p, unterminated |
| Input impedance | 573 ohms ±5% |
| Max. input voltage | 5.5 V p-p |
| Polarity | Positive or negative (follows input polarity) |
|
| Audio |
|---|
| Gain | Unbalanced output: 0 dB; balanced output: +6 dB |
| MTP input | |
| Frequency response | 20 Hz to 20 kHz, ±1 dB |
| THD + Noise | 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level |
| S/N | >70 dB at maximum output (unweighted) |
| Stereo channel separation | >60 dB @ 1 kHz |
| CMRR | >43 dB @ 20 Hz to 20 kHz |
| HDMI input | |
| Frequency response | 20 Hz to 20 kHz, ±0.06 dB |
| THD + Noise | 0.18% @ 1 kHz at nominal level |
| S/N | >76 dB at maximum output (unweighted) |
| Stereo channel separation | >63 dB @ 1 kHz |
|
| Audio input |
|---|
| MTP input | |
| Number/signal type | 2 stereo, unbalanced |
| Connectors | (1) 3.5 mm mini stereo jack
1 pair female RCA |
| Impedance | >10k ohms, unbalanced |
| Nominal level | +4 dBu (1.23 Vrms), -10 dBV (316 mVrms) |
| Maximum level | +18 dBu, (unbalanced) at 1%THD+N |
| HDMI input | |
| Number/signal type | 1 stereo, unbalanced |
| Connectors | 1 pair female RCA jacks (tip, ring) |
| Impedance | +4 dBu (1.23 Vrms), >10k ohms unbalanced, DC coupled |
| Nominal level | +4 dBu (1.23 Vrms), -10 dBV (316 mVrms) |
| Maximum level | +6.3 dBu, unbalanced at 1% THD+N |
| NOTE | 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu |
|
|
| Audio output |
|---|
| MTP output | From MTP input – see audio input specifications for the MTP receiver |
| Number/signal type | 1 set of proprietary analog signals |
| Connectors | 1 female RJ-45 |
| HDMI output | From HDMI input – see audio input specs for the HDMI receiver |
| Number/signal type | 1 stereo, balanced/unbalanced |
| Connectors | (1) 3.5 mm captive screw connector, 5 pole |
| Impedance | 50 ohms unbalanced, 100 ohms balanced |
| Maximum level (Hi-Z) | >11.4 dBu, balanced or unbalanced at 1% THD+N |
| Maximum level (600 ohm) | >5.1 dBm, balanced or unbalanced at 1% THD+N |
|
| Control/remote — external device (pass-through, unidirectional or bidirectional) , from HDMI input |
|---|
| Serial control port input | RS-232 via (1) 3.5 mm, 3 pole captive screw connector |
| Serial control port output | 1 set of proprietary signals on a female RJ-45 jack |
| NOTE | Protocol is mirrored between the transmitter and the receiver. |
|
| Serial control pin configuration | Captive screw connector: 1 = Tx, 2 = Rx, 3 = GND |
|
| General |
|---|
| Recommended cable type | Shielded or unshielded |
| MTP output | CAT 5/5e/6 |
| HDMI digital output | CAT 5/5e/6, Extron STP201 |
| NOTE | Shielded twisted pair cable provides added protection from outside interference and increases overall signal transmission distance. Extron strongly recommends using shielded twisted pair for optimal performance. |
|
| Power supply | External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts |
| Power consumption | |
| Device | MTP U T A D: 5.9 watts
HDMI 201 A D: 2.4 watts |
| Ambient temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| Cooling | Convection, no vents |
| Mounting | |
| Rack mount | No |
| Furniture mount | Wall or furniture mountable in a standard US three-gang opening |
| Enclosure type | Metal, with plastic decorator-style wall plate |
| Enclosure dimensions | |
| Faceplates | Three [2.6" H* x 1.3" W x 0.2" D (6.6 cm H* x 3.3 cm W x 0.6 cm D)]
(Fits the openings in a three-gang decorator-style wallplate.)
*Height is 4.1" [10.4 cm] including mounting tabs. |
| Device | |
| MTP | Two [2.7" H x 3.2" W x 1.5" D (6.9 cm H x 8.1 cm W x 3.8 cm D)]
(Depth excludes input connectors.) |
| HDMI | One [2.7" H x 1.8" W x 1.25" D (6.9 cm H x 4.6 cm W x 3.2 cm D)]
(Depth excludes input connectors.) |
| Product weight | 0.9 lbs (0.4 kg) |
| Vibration | ISTA 1A in carton (International Safe Transit Association) |
| Regulatory compliance | |
| Safety | CE, c-UL, UL |
| EMI/EMC | CE**, C-tick, FCC Class A**, ICES, VCCI |
| NOTE | **For the HDMI digital link, CE and FCC testing is conducted with STP (shielded twisted pair) cable. |
|
| Product warranty | 3 years parts and labor |
| NOTE | All nominal levels are at ±10%. |
|
| NOTE | Specifications are subject to change without notice. |
|
| (8.1-041817-D7) |