| TLC Pro 521M |
|
| Display |
|---|
| Screen type | Active matrix TFT color display |
| Size | 5" (12.7 cm), measured diagonally |
| Resolution | 800x480 |
| Dot/pixel pitch | 187 dpi |
| Aspect ratio | Widescreen |
| Color depth | 24-bit, 16.7M colors |
| Transparency | 8 bit alpha channel |
| Brightness | 450 nits (cd/m2) |
| Contrast | 250:1 |
| Backlight | LED |
| Viewing angle | ±70° horizontal, +50°/-70° vertical |
| Touch screen | Capacitive |
|
| Memory |
|---|
| SDRAM | 512 MB |
| Flash | 512 MB |
|
| Communication — Ethernet interface |
|---|
| Ethernet control/communications port | 1 female RJ-45 connector |
| Ethernet data rate | 10/100Base-T, half/full duplex with autodetect |
| Ethernet protocol | DHCP, DNS, HTTP, HTTPS, ICMP, SFTP, SSH, TCP/IP, UDP/IP |
| Default settings | Link speed and duplex level: autodetected
IP address = 192.168.254.252
Subnet mask = 255.255.255.0
Default gateway = 0.0.0.0
DHCP = off
DNS: 127.0.0.1 |
| Program control | Extron Global Configurator Plus and Professional
Extron GUI Designer
Toolbelt
Extron Control |
|
| Communication — touchpanel |
|---|
| Motion sensor | On/off |
| Light sensor | On/off |
|
| Communication — Digital input |
|---|
| Quantity/type | 1 digital input |
| Connector | (1) 3.5 mm captive screw connector, 2 pole |
| Digital inputs | |
| Input voltage range | 0 to 24 VDC, clamped at +30 VDC |
| Input impedance | 29k ohms |
| Upper threshold | 2.8 VDC |
| Lower threshold | 2.0 VDC |
|
| Serial control |
|---|
| Quantity/type | 1 bidirectional RS-232 |
| Connector | (1) 3.5 mm captive screw connector, 3 pole |
| Baud rate and protocol | 300 to 115200 baud (9600 baud = default); 8 (default) or 7 data bits; 1 (default) or 2 stop bits;
no parity (default), even, odd, mark, or space parity |
| Pin configuration | Pin 1 = Tx; Pin 2 = Rx; Pin 3 = Gnd |
| NOTE | This port supports software flow control. The default is no flow control. |
|
|
| Relay control |
|---|
| Quantity/type | 2 normally open relays |
| Relay control connectors | (1) 3.5 mm captive screw connector, 3 pole |
| Pin configuration | Pin 1 = relay 1; Pin 2 = relay 2; Pin 3 = common |
| Relay control contact rating | 24 VDC, 1 A |
|
| IR/serial control |
|---|
| Quantity/type | 1 programmable: unidirectional RS-232 (±5 V),
or TTL level (0 to 5 V) infrared (carrier or non-carrier) |
| Connector | (1) 3.5 mm captive screw connector, 2 pole |
| Baud rate and protocol (RS-232) | 300 to 115200 baud (9600 baud = default); 8 (default) or 7 data bits; 1 (default) or 2 stop bits;
no parity (default), even, odd, mark, or space parity |
| Pin configuration | Pin 1 = signal; Pin 2 = Gnd |
| IR output carrier frequency | 30 kHz to 300 kHz |
|
| Audio output |
|---|
| Speaker output | 1 mono, 86 dB SPL, 0.1 watt, 0.1 m, half space |
| Frequency response | 750 Hz to 20 kHz, ±5 dB |
| Playback format(s) | |
| Container format | WAV (Microsoft RIFF) |
| Encoding | LPCM (uncompressed) |
| Bit Depth | Unsigned 8-bit
Signed 16-bit
Signed 24-bit
Signed 32-bit |
| Sampling rate | 2 kHz to 192 kHz |
| Audio channels | mono or stereo |
|
| General |
|---|
| Power supply | Not included |
| Power input requirements | 12 VDC
or Power over Ethernet (PoE 802.3af, class 3) |
| Power consumption — Power injector (XTP PI 100) |
| Device | 6.0 watts |
| Device and power injector | 8.7 watts |
| Power consumption — PoE PSE |
| Device | 6.1 watts |
| Power consumption — 12 VDC power supply (PS 1210C) |
| Device | 4.3 watts |
| Device and power supply | 5.8 watts |
| Ambient temperature/humidity | Storage: -22 to +158 °F (-30 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| Cooling | Convection, vents on top and sides |
| Thermal dissipation — Power injector (XTP PI 100) |
| Device | 20.2 BTU/hr |
| Device and power injector | 29.6 BTU/hr |
| Thermal dissipation — PoE PSE |
| Device | 20.5 BTU/hr |
| Thermal dissipation — 12 VDC power supply (PS 1210C) |
| Device | 14.6 BTU/hr |
| Device and power supply | 19.7 BTU/hr |
| Mounting | |
| Furniture or wall mount | With included hardware |
| Enclosure type | Plastic |
| |  |
| Enclosure dimensions | |
| Faceplate | 6.38" W x 4.61" H x 0.59" D
(16.2 cm W x 11.7 cm H x 1.5 cm D) |
| Enclosure | 5.43" W x 3.74" H x 1.64" D
(13.8 cm W x 9.5 cm H x 4.2 cm D) |
| Product weight | 0.76 lbs (0.34 kg) |
| Vibration | ISTA 1A in carton (International Safe Transit Association) |
| Regulatory compliance | |
| Safety | CE, c-UL, UL |
| EMI/EMC | CE, C-tick,FCC Class A, ICES, VCCI |
| Environmental | Complies with the appropriate requirements of RoHS and WEEE. |
| Product warranty | 3 years parts and labor; touchpanel display and overlay components are covered for 1 year |
| NOTE | All nominal levels are at ±10%. |
|
| NOTE | Specifications are subject to change without notice. |
|
| (8.1-040716-D2) |