| DXP HDMI Series |
| NOTE | *Appropriate HDMI to DVI-D cables or adapters are required for DVI signal input/output. |
|
|
| Video |
|---|
| Routing | |
| DXP 44 HDMI | 4 x 4 matrix |
| DXP 48 HDMI | 4 x 8 matrix |
| DXP 84 HDMI | 8 x 4 matrix |
| DXP 88 HDMI | 8 x 8 matrix |
| Signal Type | TMDS digital RGB HDMI and single-link DVI digital video signals are supported |
| Digital video | RGB digital video (DVI and HDMI standards) or Y, Cr, Cb digital component video (HDMI), actively buffered (supports all single-link DVI and HDMI [if using an optional adapter] standards from 640x480 @ 60 Hz to 1600x1200 @ 60 Hz computer video and HDTV 480p, 720p, 1080i, 1080p) |
| NOTE | The DXP HDMI Series switchers support TMDS data rates up to 6.75 Gbps, Deep Color up to 12-bit, 3D**, HD lossless audio, and other HDMI 1.3 specification features.
**Extron strongly recommends compatibility testing while designing and before installing any 3D system. There are several unique 3D formats in use by source devices and display manufacturers. The level of 3D product support is governed by pixel clock, signal format, and communication between source and sink devices. Please contact an Extron Application Engineer for more information.
|
|
| Digital audio | Supports HDMI audio transmitted through the RGB and Y, Cr, Cb lines, actively buffered. |
| Consumer Electronics Control (CEC) | Not supported |
| EDID and DDC | Supports Extended Display Identification Data (EDID) and Display Data Channel (DDC) data using DVI and HDMI standards. EDID and DDC signals are actively buffered. |
| HDCP | Compliant with High-bandwidth Digital Content Protection (HDCP) using DVI and HDMI standards |
| HPD | Supports hot plug detection (HPD) of display as a pass-through signal. |
| Gain | Unity |
| Resolution range | Up to 1080p (HDTV) or 1920x1200 (the highest resolution of the single-link DVI standard) @ 60 Hz |
| Maximum data rate | 6.75 Gbps (2.25 Gbps per color) |
| Maximum pixel clock | 165 MHz |
| Standards | DVI 1.0, HDMI 1.3 |
| Switching speed | 200 ns, max. |
|
| Video input |
|---|
| Number/signal type | 4 or 8 (depending on model) digital RGB (TMDS) HDMI (or single-link DVI-D*) |
| Connectors | 4 or 8 female HDMI type A (digital only) |
| Nominal level | |
| Digital video | 1.2 Vp-p |
| DDC (Display Data Channel) | 5.0 Vp-p (TTL) |
| Minimum/maximum level | 0.5 V to 1.0 Vp-p with no offset |
| Impedance | 100 ohms |
| Return loss | <-15 dB @ 1 MHz to 1.5 GHz |
| TDR rise time (10%-90%) | 75 ps |
| Equalization | Automatic |
| Input cable length | >100' (30 m) at 1920x1200 @ 48, 50, or 60 Hz; or 1080p; 8 bit color |
| NOTE | The transmission distance varies depending on the signal resolution and on the type of cable, graphic card, and display used in the system. |
|
|
| Video output |
|---|
| Number/signal type | 4 or 8 (depending on model) digital RGB |
| Connectors | 4 or 8 female HDMI type A |
| Nominal level | 1.2 Vp-p |
| Minimum/maximum level(s) | 0.5 V to 1.0 Vp-p with no offset (follows input) |
| Impedance | 100 ohms |
| Return loss | <-15 dB @ 1 MHz to 1.5 GHz |
| DC offset | ±500 mV maximum with input at 0 offset |
| Rise and fall time (20-80%) | 0.6 ns |
| Re-clocking | Automatic |
| Peripheral device power | 250 mA per output |
|
| Communication |
|---|
| Serial control port | (1) RS-232, 9-pin female D connector
(1) RS-232, front panel 2.5 mm mini stereo jack |
| Baud rate and protocol | 9600 to 115200 baud, 9600 baud (default), 8 data bits, 1 stop bit, no parity |
| Serial control pin configurations | |
| 9-pin D connector | 2 = Tx, 3 = Rx, 5 = GND |
| Mini stereo jack | Tip = Tx, ring = Rx, sleeve = GND |
| Ethernet control port | (1) RJ-45 female connector |
| Ethernet data rate | 10/100Base-T, half/full duplex with autodetect |
| Ethernet protocol | ARP, ICMP (ping), IP, TCP, DHCP, HTTP, Telnet |
| Default settings | Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off |
| Program control | Extron control/configuration program for Windows®
Extron Simple Instruction Set (SIS™)
Microsoft® Internet Explorer® ver. 6 or higher, Telnet |
|
| General |
|---|
| Power supply | Internal
Input: 100-240 VAC, 50-60 Hz |
| Power consumption | 48 watts, fully loaded 8 x 8 unit |
| Ambient temperature/humidity | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| Cooling | Fan, air flows right to left (as viewed from front) |
| Thermal dissipation, full load | 164 BTU/hr |
| Mounting | |
| Rack mount | Yes, 2U high |
| Enclosure type | Metal |
| Enclosure dimensions | 3.5" H x 17.5" W x 12.0" D (2U high, full rack wide)
(8.9 cm H x 44.4 cm W x 30.5 cm D)
(Depth excludes connectors. Width excludes integrated rack ears.) |
| Product weight | 10.0 lbs (4.5 kg) |
| Shipping weight | 15 lbs (7 kg) |
| Vibration | ISTA 1A in carton (International Safe Transit Association) |
| Regulatory compliance | |
| Safety | BSMI, CE, c-UL, EAC, UL |
| Compliances | CE, C-tick, FCC Class A, ICES, KCC, VCCI |
| Product warranty | 3 years parts and labor |
| NOTE | All nominal levels are at ±10%. |
|
| NOTE | Specifications are subject to change without notice. |
|
| (8.1-060115-D12) |