ACP 106 D

ACP 106 D

1. Provide a one-gang decorator-style button panel for the purpose of remotely controlling, monitoring and troubleshooting connected DMP 128 Plus Digital Matrix Processor systems.
   1. Fully-customizable ACP enabled button panel interface.
      1. Device shall have a total of six fully-customizable soft-touch, backlit buttons, two dedicated for mute, two dedicated for volume control and the remaining two available for other functions
         1. Buttons shall illuminate white when active and shall have the ability to flash.
         2. Buttons shall feature two levels of illumination, dim and bright.
         3. Button text shall be able to be customized by using an online custom button application.
      2. Device shall have five LEDs, arranged horizontally located just above the volume buttons, that shall provide visual feedback of the gain setting of the Gain Group associated with the dedicated volume control buttons
      3. Provides two ACP ports on the rear panel that accept 4-pole, 3.5mm captive screw connectors, for power and communication via the connection to a DMP 128 Plus Digital Matrix Processor.
         1. These ports are also used to add additional ACP panels in a Daisy Chain.
      4. Device shall feature a 6-pole dip switch for assigning a unique Bus ID to the button panel.
      5. Device shall include a reset button that resets the device back to original factory settings.
      6. Device shall feature a diagnostic status LED that will be used as a visual indication that the ACP panel is communicating properly with the DMP 128 Plus Digital Matrix Processor.
      7. Device shall provide audible feedback from the built-in speaker by beeping when a button is pressed.
      8. Device shall be Section 508 compliant and shall meet or exceed U.S. accessibility standards for Electronic Information Technology.
      9. Device may be wired using a Daisy Chain topology.
         1. The cable length of a Daisy Chain may not exceed a sum total 1,000 feet.
      10. ACP supports up to four panels per one DMP 128 Plus Digital Matrix Processor.
      11. ACP supports the following cabling types:
          1. Extron STP20-2 Cable
          2. CAT5e or CAT 6 cable, the cable must be 23 AWG solid copper wire.
      12. ACP supports power and communication over a single cable.
      13. Supports configuration and setup by Extron DSP Configurator Software.
   2. Mounting requirements
      1. Device shall have the ability to be mounted directly in a wall, lectern, or other flat surface and shall be able to be secured using the supplied mud ring and hardware.
      2. Device shall have the ability to be mounted to the surface of a wall using an optional wall box.
      3. Device shall include both white and black faceplates.
   3. Software requirements
      1. Device shall be configured using DSP Configurator:
         1. Buttons will support the following button actions:
            1. Group Mute On/Off
            2. Group Volume Up/Down
            3. Preset Recall/Toggle
            4. Macro Recall/Toggle
            5. Shall meet regulatory compliances
            6. CE
      2. c-UL
      3. UL
      4. C-Tick
      5. FCC Class A
      6. ICES
      7. VCCI class A
   4. Product Warranty
      1. Shall provide 3 years parts and labor
   5. Approved device shall be the Extron ACP 106 D part number 60-1645-13; no alternates or equals